HPE FlexFabric 5950 Series

196
Syntax
reset udp-helper statistics
Views
User view
Predefined user roles
network-admin
Examples
# Clear the statistics about broadcast to unicast conversion by UDP helper.
<Sysname> reset udp-helper statistics
Related commands
display udp-helper interface
udp-helper broadcast-map
Use udp-helper broadcast-map to specify a multicast address for UDP helper to convert broadcast
to multicast.
Use undo udp-helper broadcast-map to restore the default.
Syntax
udp-helper broadcast-map multicast-address [ acl acl-number ]
undo udp-helper broadcast-map multicast-address
Default
No multicast address is specified for UDP helper to convert broadcast to multicast.
Views
Interface view
Predefined user roles
network-admin
Parameters
multicast-address: Specifies the destination multicast address to which the destination broadcast
address is converted.
acl acl-number: Specifies an ACL by its number. The ACL filters incoming broadcast packets for
UDP helper. Packets permitted by the ACL can be converted. If no ACL is specified, all incoming
broadcast packets are checked for UDP helper.
• For a basic ACL, the value range is 2000 to 2999.
• For an advanced ACL, the value range is 3000 to 3999.
Usage guidelines
Use this command on the interface that receives broadcast packets.
You can configure a maximum of 20 unicast and multicast addresses for UDP helper to convert
broadcast packets.
Examples
# Configure UDP helper to convert received broadcast packets on VLAN-interface 100 to multicast
packets destined for 225.0.0.1.
<Sysname> system-view