HPE FlexFabric 5950 Series

99
undo remote-server [ ip-address&<1-8> ]
Default
No DHCP server is specified for the DHCP address pool.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
ip-address&<1-8>: Specifies a space-separated list of up to eight DHCP server addresses.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
If you do not specify a DHCP server address, the undo remote-server command removes all DHCP
servers in the DHCP address pool.
Examples
# Specify DHCP server 10.1.1.1 for DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] remote-server 10.1.1.1
remote-server algorithm
Use remote-server algorithm to specify the DHCP server selecting algorithm.
Use undo remote-server algorithm to restore the default.
Syntax
remote-server algorithm { master-backup | polling }
undo remote-server algorithm
Default
The polling algorithm is used. The DHCP relay agent forwards DHCP requests to all DHCP servers
at the same time.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
master-backup: Forwards DHCP requests to the master DHCP server first. If the master server is
not available or does not have assignable IP addresses, the relay agent forwards DHCP requests to
backup DHCP servers in the order they are specified.
polling: Forwards DHCP requests to all DHCP servers at the same time.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.