HPE FlexFabric 5950 Series

77
undo verify class
Default
The DHCP user class whitelist is disabled.
Views
DHCP address pool view
Predefined user roles
network-admin
Usage guidelines
After you enable the DHCP user class whitelist, the DHCP server processes requests only from
clients on the DHCP user class whitelist.
The DHCP user class whitelist does not take effect on clients that request static IP addresses, and
the server always processes their requests.
Examples
# Enable the DHCP user class whitelist in DHCP address pool 0.
[Sysname] system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] verify class
Related commands
valid class
voice-config
Use voice-config to configure the content for Option 184 in a DHCP address pool.
Use undo voice-config to remove the Option 184 content from a DHCP address pool.
Syntax
voice-config { as-ip ip-address | fail-over ip-address dialer-string | ncp-ip ip-address | voice-vlan
vlan-id { disable | enable } }
undo voice-config [ as-ip | fail-over | ncp-ip | voice-vlan ]
Default
No Option 184 content is configured in a DHCP address pool.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
as-ip ip-address: Specifies the IP address of the backup network calling processor.
fail-over ip-address dialer-string: Specifies the failover IP address and dialer string. The dialer-string
is a string of 1 to 39 characters. Valid characters are digits and asterisk (*).
ncp-ip ip-address: Specifies the IP address of the primary network calling processor.
voice-vlan vlan-id: Specifies the voice VLAN ID in the range of 2 to 4094.
• disable: Disables the specified VLAN. DHCP clients will not take this VLAN as their voice
VLAN.