HPE FlexFabric 5950 Series

39
Examples
# Specify DHCP address pool pool1 as the default DHCP address pool in DHCP policy 1.
<Sysname> system-view
[Sysname] dhcp policy 1
[Sysname-dhcp-policy-1] default ip-pool pool1
Related commands
class ip-pool
dhcp policy
dhcp apply-policy
Use dhcp apply-policy to apply a DHCP policy to an interface.
Use undo dhcp apply-policy to restore the default.
Syntax
dhcp apply-policy policy-name
undo dhcp apply-policy
Default
No DHCP policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
policy-name: Specifies a DHCP policy by its name, a case-insensitive string of 1 to 63 characters.
Usage guidelines
You can apply only one DHCP policy to an interface. If you execute this command multiple times, the
most recent configuration takes effect.
Examples
# Apply DHCP policy test to VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] dhcp apply-policy test
Related commands
dhcp policy
dhcp class
Use dhcp class to create a DHCP user class and enter its view, or enter the view of an existing
DHCP user class.
Use undo dhcp class to delete the specified DHCP user class.
Syntax
dhcp class class-name