HPE FlexFabric 5950 Series

117
dhcp snooping max-learning-num
Use dhcp snooping max-learning-num to set the maximum number of DHCP snooping entries
that an interface can learn.
Use undo dhcp snooping max-learning-num to restore the default.
Syntax
dhcp snooping max-learning-num max-number
undo dhcp snooping max-learning-num
Default
The maximum number of DHCP snooping entries for an interface to learn is unlimited.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
Layer 3 Ethernet interface/Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
max-number: Specifies the maximum number of DHCP snooping entries for an interface to learn.
The value range is 1 to 4294967295.
Examples
# Allow Layer 2 Ethernet interface HundredGigE 1/0/1 to learn a maximum of 10 DHCP snooping
entries.
<Sysname> system-view
[Sysname] interface hundredgige 1/0/1
[Sysname-HundredGigE1/0/1] dhcp snooping max-learning-num 10
dhcp snooping rate-limit
Use dhcp snooping rate-limit to enable DHCP snooping packet rate limit on an interface and set
the limit value.
Use undo dhcp snooping rate-limit to disable DHCP snooping packet rate limit.
Syntax
dhcp snooping rate-limit rate
undo dhcp snooping rate-limit
Default
The DHCP snooping packet rate limit is disabled on an interface.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
rate: Specifies the maximum rate in Kbps. The value range is 64 to 512.