164
IRDP commands
ip irdp
Use ip irdp to enable IRDP on an interface.
Use undo ip irdp to disable IRDP on an interface.
Syntax
ip irdp
undo ip irdp
Default
IRDP is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
This command validates the IRDP settings on an interface. After the IRDP is enabled on an interface,
the device can send RA messages out of the interface.
Examples
# Enable IRDP on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip irdp
ip irdp address
Use ip irdp address to specify an IP address for an interface to proxy-advertise.
Use undo ip irdp address to remove the specified proxy-advertised IP address.
Syntax
ip irdp address ip-address preference-value
undo ip irdp address [ ip-address ]
Default
No proxy-advertised IP address is specified.
Views
Interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies an IP address in dotted decimal notation.
To Next Page
Loading...
Need help?
General