251
ipv6 reassemble local enable
Use ipv6 reassemble local enable to enable IPv6 local fragment reassembly.
Use undo ipv6 reassemble local enable to disable IPv6 local fragment reassembly.
Syntax
ipv6 reassemble local enable
undo ipv6 reassemble local enable
Default
IPv6 local fragment reassembly is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Configure this command on a multichassis IRF fabric to improve fragment reassembly efficiency.
The command enables the subordinate to reassemble the IPv6 fragments of a packet if all the
fragments arrive at it. If this feature is disabled, all IPv6 fragments are delivered to the master for
reassembly. The command applies only to fragments destined for the same subordinate.
Examples
# Enable IPv6 local fragment reassembly.
<Sysname> system-view
[Sysname] ipv6 reassemble local enable
ipv6 redirects enable
Use ipv6 redirects enable to enable sending ICMPv6 redirect messages.
Use undo ipv6 redirects enable to disable sending ICMPv6 redirect messages.
Syntax
ipv6 redirects enable
undo ipv6 redirects enable
Default
Sending ICMPv6 redirect messages is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
The default gateway sends an ICMPv6 redirect message to the source of an IPv6 packet to inform
the source of a better first hop.
Sending ICMPv6 redirect messages enables hosts that hold few routes to establish routing tables
and find the best route. Because this feature adds host routes into the routing tables, host
To Next Page
Loading...
