246
To delete a static neighbor entry for a VLAN interface, specify only the corresponding VLAN
interface.
Examples
# Configure a static neighbor entry for VLAN-interface 1.
<Sysname> system-view
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 interface Vlan-interface 1
Related commands
display ipv6 neighbors
reset ipv6 neighbors
ipv6 neighbor link-local minimize
Use ipv6 neighbor link-local minimize to minimize link-local ND entries.
Use undo ipv6 neighbor link-local minimize to restore the default.
Syntax
ipv6 neighbor link-local minimize
undo ipv6 neighbor link-local minimize
Default
All ND entries are assigned to the driver.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Perform this command to minimize link-local ND entries assigned to the driver. Link-local ND entries
refer to ND entries that contain link-local addresses.
With this feature enabled, the device does not add newly learned link-local ND entries whose link
local addresses are not the next hop of any route to the driver. This saves driver resources.
This feature affects only newly learned link-local ND entries rather than existing ND entries.
Examples
# Minimize link-local ND entries.
<Sysname> system-view
[Sysname] ipv6 neighbor link-local minimize
ipv6 neighbor stale-aging
Use ipv6 neighbor stale-aging to set the aging timer for ND entries in stale state.
Use undo ipv6 neighbor stale-aging to restore the default.
Syntax
ipv6 neighbor stale-aging aging-time
undo ipv6 neighbor stale-aging
To Next Page
Loading...
Need help?
General