HPE FlexFabric 5950 Series Command Reference

162
IPv6 adjacency table commands
display ipv6 adjacent-table
Use display ipv6 adjacent-table to display IPv6 adjacency entries.
Syntax
display ipv6 adjacent-table { all | physical-interface interface-type interface-number |
routing-interface interface-type interface-number | slot slot-number } [ count | verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Displays all IPv6 adjacency entries.
physical-interface interface-type interface-number: Displays IPv6 adjacency entries about the
specified physical interface.
routing-interface interface-type interface-number: Displays IPv6 adjacency entries about the
specified routing interface.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays IPv6 adjacency entries for all member devices.
count: Displays the number of IPv6 adjacency entries.
verbose: Displays detailed information about IPv6 adjacency entries.
Examples
# Display detailed information about all IPv6 adjacency entries.
<Sysname> display ipv6 adjacent-table all verbose
IPv6 address : N/A
Routing interface : Tunnel1
Physical interface : Tunnel1
Logical interface : N/A
Service type : Tunnel
Action type : Forwarding
Link media type : P2P
Slot : 1
Cpu : 0
VPN index : 0
Virtual circuit information : N/A
Link head information(IPv6) : 4500000000000000ff2f000002020201020202020000
86dd
Link head information(MPLS) : 4500000000000000ff2f000002020201020202020000
86dd
# Display IPv6 adjacency entries for the specified slot.
<Sysname> display ipv6 adjacent-table slot 1

HPE FlexFabric 5950 Series Specifications

General

Brand	HPE
Model	FlexFabric 5950 Series
Category	Switch
Language	English