HPE FlexFabric 5950 Series

95
Table 15 Command output
Field Description
Interface Interface name.
Status
Option 82 states:
• Enable—DHCP relay agent support for Option 82 is enabled.
• Disable—DHCP relay agent support for Option 82 is disabled.
Strategy
Handling strategy for request messages containing Option 82,
Drop
,
Keep
, or
Replace
.
Circuit ID Pattern
Padding content mode of the Circuit ID sub-option,
Verbose
,
Normal
, or
User Defined
.
Remote ID Pattern
Padding content mode of the Remote ID sub-option,
Sysname
,
Normal
,
or
User Defined
.
Circuit ID format-type Padding format of the Circuit ID sub-option,
ASCII
,
Hex
, or
Undefined
.
Remote ID format-type Padding format of the Remote ID sub-option,
ASCII
,
Hex
, or
Undefined
.
Node identifier Access node identifier.
User defined Content of the user-defined sub-options.
Circuit ID User-defined content of the Circuit ID sub-option.
Remote ID User-defined content of the Remote ID sub-option.
display dhcp relay server-address
Use display dhcp relay server-address to display DHCP server addresses configured on an
interface.
Syntax
display dhcp relay server-address [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Displays DHCP server addresses on the specified
interface. If you do not specify an interface, this command displays DHCP server addresses on all
interfaces.
Examples
# Display DHCP server addresses on all interfaces.
<Sysname> display dhcp relay server-address
Interface name Server IP address
Vlan2 2.2.2.2