HPE FlexFabric 5950 Series

97
DHCP packets relayed to clients: 0
DHCPOFFER: 0
DHCPACK: 0
DHCPNAK: 0
BOOTPREPLY: 0
DHCP packets sent to servers: 0
DHCPDISCOVER: 0
DHCPREQUEST: 0
DHCPINFORM: 0
DHCPRELEASE: 0
DHCPDECLINE: 0
BOOTPREQUEST: 0
DHCP packets sent to clients: 0
DHCPOFFER: 0
DHCPACK: 0
DHCPNAK: 0
BOOTPREPLY: 0
Related commands
reset dhcp relay statistics
gateway-list
Use gateway-list to specify gateway addresses for DHCP clients in a DHCP address pool.
Use undo gateway-list to remove gateway addresses from a DHCP address pool.
Syntax
gateway-list ip-address&<1-64>
undo gateway-list [ ip-address&<1-64> ]
Default
No gateway address is specified in a DHCP address pool.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
ip-address&<1-64>: Specifies a space-separated list of up to 64 addresses.
Usage guidelines
DHCP clients of the same access type can be classified into different types by their locations. In this
case, the relay interface typically has no IP address configured. You can use the gateway-list
command to specify gateway addresses for clients matching the same DHCP address pool and bind
the gateway addresses to the device's MAC address.
Upon receiving a DHCP DISCOVER or REQUEST from a client that matches a DHCP address pool,
the relay agent processes the packet as follows:
1. Fills the giaddr field of the packet with a specified gateway address.
2. Forwards the packet to all DHCP servers in the matching DHCP address pool.