153
Load sharing commands
display ip load-sharing path
Use display ip load-sharing path to display the load sharing path selected for a flow.
Syntax
display ip load-sharing path ingress-port interface-type interface-number packet-format
{ ipv4oe dest-ip ip-address [ src-ip ip-address ] | ipv6oe dest-ipv6 ipv6-address [ src-ipv6
ipv6-address ] } [ dest-port port-id | ip-pro protocol-id | src-port port-id | vpn-instance
vpn-instance-name ] *
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ingress-port interface-type interface-number: Specifies an ingress port by its type and number.
packet-format: Specifies the packet encapsulation format.
ipv4oe: Specifies the format of IPv4 over Ethernet.
dest-ip ip-address: Specifies the destination IPv4 address in dotted decimal notation. If you do not
specify this argument, the calculation uses 0.0.0.0 for path selection.
src-ip ip-address: Specifies the source IPv4 address in dotted decimal notation. If you do not specify
this argument, the calculation uses 0.0.0.0 for path selection.
ipv6oe: Specifies the format of IPv6 over Ethernet.
dest-ipv6 ipv6-address: Specifies the destination IPv6 address. If you do not specify this option, the
calculation uses 0:0:0:0:0:0:0:0 for path selection.
src-ipv6 ipv6-address: Specifies the source IPv6 address. If you do not specify this option, the
calculation uses 0:0:0:0:0:0:0:0 for path selection.
dest-port port-id: Specifies a destination port number in the range of 1 to 65535. If you do not specify
this option, the calculation uses 0 for path selection.
ip-pro protocol-id: Specifies an IP protocol by its number in the range of 1 to 65535. If you do not
specify this option, the calculation uses 0 for path selection.
source-port port-id: Specifies a source port number in the range of 1 to 65535. If you do not specify
this option, the calculation uses 0 for path selection.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a
case-sensitive string of 1 to 31 characters. To display the path on the public network, do not specify
this option.
Usage guidelines
When you configure this command, make sure the options are the same as those in the ip
load-sharing mode command. If the options are not consistent, the path displayed by this command
might be different from the real path for load sharing.
To Next Page
Loading...
Need help?
General