HPE FlexFabric 5950 Series Command Reference

322
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
vlan vlan-id: Pads the remote ID for packets received from the specified VLAN. If you do not specify
a VLAN, the device pads the remote ID for packets received from the default VLAN.
remote-id: Specifies the a string of 1 to 128 characters as the remote ID.
Examples
# Specify device001 as the remote ID.
<Sysname> system-view
[Sysname] ipv6 dhcp snooping enable
[Sysname] interface hundredgige 1/0/1
[Sysname-HundredGigE1/0/1] ipv6 dhcp snooping option remote-id enable
[Sysname-HundredGigE1/0/1] ipv6 dhcp snooping option remote-id string device001
Related commands
ipv6 dhcp snooping enable
ipv6 dhcp snooping option remote-id enable
ipv6 dhcp snooping rate-limit
Use ipv6 dhcp snooping rate-limit to enable DHCPv6 snooping packet rate limit on an interface
and set the limit value.
Use undo ipv6 dhcp snooping rate-limit to disable DHCPv6 snooping packet rate limit.
Syntax
ipv6 dhcp snooping rate-limit rate
undo ipv6 dhcp snooping rate-limit
Default
The DHCPv6 snooping packet rate limit is disabled on an interface.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
rate: Specifies the maximum rate in Kbps. The value range is 64 to 512.
Usage guidelines
This command takes effect only when DHCPv6 snooping is enabled.
The DHCPv6 packet rate limit feature enables the interface to discard DHCPv6 packets that exceed
the maximum rate.
The rate configured on a Layer 2 aggregate interface applies to all members of the aggregate
interface. If a member interface leaves the aggregation group, it uses the rate configured in its
Ethernet interface view.

HPE FlexFabric 5950 Series Specifications

General

Brand	HPE
Model	FlexFabric 5950 Series
Category	Switch
Language	English