43
Parameters
pool-name: Specifies the name of a DHCP address pool, a case-insensitive string of 1 to 63
characters.
Usage guidelines
Upon receiving a DHCP request from the interface, the DHCP server searches for a static binding for
the client from all address pools. If no static binding is found, the server assigns configuration
parameters from the address pool applied on the interface to the client. If the address pool has no
assignable IP address or does not exist, the DHCP client cannot obtain an IP address.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Apply DHCP address pool 0 to VLAN-interface 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] dhcp server apply ip-pool 0
Related commands
dhcp server ip-pool
dhcp server bootp ignore
Use dhcp server bootp ignore to configure the DHCP server to ignore BOOTP requests.
Use undo dhcp server bootp ignore to restore the default.
Syntax
dhcp server bootp ignore
undo dhcp server bootp ignore
Default
The DHCP server does not ignore BOOTP requests.
Views
System view
Predefined user roles
network-admin
Usage guidelines
The lease duration of IP addresses obtained by BOOTP clients is unlimited. For scenarios that do not
allow unlimited leases, you can configure the DHCP server to ignore BOOTP requests.
Examples
# Configure the DHCP server to ignore BOOTP requests.
<Sysname> system-view
[Sysname] dhcp server bootp ignore
dhcp server bootp reply-rfc-1048
Use dhcp server bootp reply-rfc-1048 to enable the sending of BOOTP responses in RFC 1048
format.
Use undo dhcp server bootp reply-rfc-1048 to disable this feature.
To Next Page
Loading...
