EasyManua.ls Logo

HPE FlexFabric 5950 Series

HPE FlexFabric 5950 Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
Table 3 Command output
Field Description
current state
Physical link state of the interface:
• Administrative DOWN—The interface has been shut down by using
the shutdown command.
• DOWN—The interface is administratively up, but its physical state is
down (possibly because no physical link exists or the link has failed).
• UP—The interface is both administratively and physically up.
Line protocol current state
Data link layer state of the interface.
• DOWN—The data link layer protocol is down.
• UP—The data link layer protocol is up.
• UP (spoofing)—The data link layer protocol is up, but the link is an
on-demand link or does not exist.
Internet Address
IP address of an interface followed by:
• Primary—A primary IP address.
• Sub—A secondary IP address.
• MTunnel—An MTunnel interface IP address.
• SSLVPN—An SSL VPN interface IP address.
• Unnumbered—An unnumbered IP address.
• DHCP-Allocated—An IP address obtained through DHCP.
• BOOTP-Allocated—An IP address obtained through BOOTP.
• Mad—A MAD IP address.
• IRF-Member—IP address of the management Ethernet port of an IRF
member device.
Broadcast address Broadcast address of the subnet attached to an interface.
The Maximum Transmit Unit MTU of the interface, in bytes.
input packets, bytes,
multicasts
output packets, bytes,
multicasts
All received and sent packets and bytes, and received and sent multicast
packets on an interface (statistics start at the device startup).
TTL invalid packet number
Number of TTL-invalid packets received on the interface (statistics start at
the device startup).
ICMP packet input number:
Echo reply:
Unreachable:
Source quench:
Routing redirect:
Echo request:
Router advert:
Router solicit:
Total number of ICMP packets received on the interface (statistics start at
the device startup):
• Echo reply packets.
• Unreachable packets.
• Source quench packets.
• Routing redirect packets.
• Echo request packets.
• Router advertisement packets.
• Router solicitation packets.

Table of Contents

Other manuals for HPE FlexFabric 5950 Series

Related product manuals