EasyManua.ls Logo

HPE MSR3000 - Page 30

HPE MSR3000
371 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
•
Condition: This symptom might occur if the old pre-shared key is not deleted when the new key
is set.
201602170270
•
Symptom: On a CDMA-1xRTT/CDMA-EVDO network, 3G VPDN access fails if the mode of the
SIC-4G-LTE module is switched to 3G.
•
Condition: This symptom might occur if the mode of the SIC-4G-LTE module is switched to 3G.
201601260255
•
Symptom: After the router reboots, BFD sessions cannot be set up on subinterfaces that are in
an aggregation group.
•
Condition: This symptom might occur if the router reboots.
201603150157
•
Symptom: IMC obtains incorrect packet statistics for Layer 2 interfaces on an MSR2004-24
router.
•
Condition: This symptom might occur if IMC reads the packet statistics on Layer 2 interfaces of
an MSR2004-24 router.
201602260225
•
Symptom: An interface on an SIC-4/9FSW module cannot send broadcast traffic in its VLAN
after certain operations are performed.
•
Condition: This symptom might occur if the following operations are performed:
a. Enable STP globally, and form a loop on an interface of an SIC-4/9FSW module.
b. Remove the blocked interface from its VLAN.
c. Disable STP globally, and assign the interface to its original VLAN.
201602260270
•
Symptom: The router does not display the command execution result after AT commands are
manually executed.
•
Condition: None.
201603110385
•
Symptom: The router does not send a trap message after a warm or cold reboot.
•
Condition: This symptom might occur if a warm or cold reboot is performed.
201603240091
•
Symptom: Dialup fails if a 4G module is operating in 3G mode.
•
Condition: This symptom might occur if the following operations are performed:
a. Install a 4G SIM card in a 4G module.
b. Set the mode of the 4G module to 3G, and reboot the module.
201603100323
•
Symptom: When a portal preauthentication domain and MAC-based quick portal authentication
are used together, authorization attributes in the preauthentication domain do not take effect on
preauthentication users.
•
Condition: This symptom might occur if a portal preauthentication domain and MAC-based
quick portal authentication are used together, and MAC-based quick portal authentication is
triggered when preauthentication users access the network.

Table of Contents