EasyManua.ls Logo

HPE MSR3000 - Page 34

HPE MSR3000
371 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
201602240243
•
Symptom: The router might reboot unexpectedly after running for 497 days.
•
Condition: None.
201602010060
•
Symptom: RIP route filtering settings on the router are lost after the running configuration is
saved and the router is rebooted.
•
Condition: This symptom might occur if one of the following operations is performed:
Upgrade the software and reboot the router.
Use a .cfg configuration file when rebooting the router.
201603090066
•
Symptom: An ADVPN tunnel cannot be set up if a loopback interface provides the tunnel source
address and the physical tunnel outgoing interface is a NAT-enabled PPPoE dialer interface.
•
Condition: This symptom might occur if a loopback interface provides the tunnel source address
and the physical tunnel outgoing interface is a NAT-enabled PPPoE dialer interface.
201603090064
•
Symptom: The DVPN service is interrupted during IPsec SA renegotiation.
•
Condition: This symptom might occur if the IPsec SA expires and IPsec SA renegotiation is
performed.
201603020540
•
Symptom: The memory usage keeps rising if no ACL is specified for an IPsec policy template.
•
Condition: This symptom might occur if no ACL is specified for an IPsec policy template.
201601120419
•
Symptom: An NMS returns an error when it reads the 3G modem table from the MIB of the
router.
•
Condition: This symptom might occur if two SIC-3G cards are installed on the router.
201601160235
•
Symptom: The router as a PPPoE server has duplicate PPPoE client information.
•
Condition: None.
201601180617
•
Symptom: The global DHCP address pool usage is incorrect.
•
Condition: None.
201601260049
•
Symptom: The router reboots unexpectedly when it receives GRE packets with the DF bit set.
•
Condition: This symptom might occur if the router receives GRE packets with the DF bit set.
201601190036
•
Symptom: The secondary IP addresses of a Virtual-Template interface are unavailable.
•
Condition: None.
201601210335
•
Symptom: The PPP IP segment match feature does not take effect if the
user-basic-service-ip-type { ipv4 | ipv6 | ipv6-pd } command is not configured.

Table of Contents