HPE MSR3000 User Manual

47
201507020391
•
Symptom: The TTL of a static blacklist entry is different from the actual aging time.
•
Condition: This symptom occurs if the static blacklist entry is added after a master/subordinate
switchover in an IRF fabric.
201505150461
•
Symptom: An interface cannot forward packets when it is up.
•
Condition: This symptom occurs if a large number of portal users come online and go offline
through the interface.
201506100261
•
Symptom: ARP reply packets are forwarded through the trusted interface even if there is a
match in the MAC address table.
•
Condition: This symptom occurs when ARP restricted forwarding is enabled.
201506120046
•
Symptom: The ToS bits in the outer IP header are not set to the same as the ToS bits in the
inner header after IP packets are encapsulated with MPLS L3VPN or GRE.
•
Condition: This symptom occurs if IP packets are encapsulated with MPLS L3VPN or GRE.
201506230020
•
Symptom: A POS interface cannot forward packets that are greater than 2048 bytes.
•
Condition: None.
201504270304
•
Symptom: Only up to 256 ports can be specified in one nat server command.
•
Condition: None.
201503110416
•
Symptom: Assertion information is displayed and accounting stops when a user comes online.
•
Condition: This symptom occurs if the accounting quota-out redirect-url command is
configured.
201411190412
•
Symptom: The tunnel source cannot return Packet Too Big messages for packets tunneled
through an IPv6 over IPv4 tunnel.
•
Condition: This symptom occurs when fragmentation check is enabled for packets to be
tunneled.
201503090076
•
Symptom: IPv4 addresses must be configured on the AFTR of a DS-Lite tunnel.
•
Condition: This symptom occurs when the AFTR of a DS-Lite tunnel is configured.
201507070230
•
Symptom: The router establishes calls slowly when using R2 signaling.
•
Condition: This symptom occurs if R2 signaling is used.
201505200402
•
Symptom: Too much log information is displayed after RTP packets are interrupted.
•
Condition: This symptom occurs if the network link fails after a call is established.

HPE MSR3000 Specifications

General

Brand	HPE
Model	MSR3000
Category	Network Router
Language	English