5
GPS/GPS-A OPERATION
5-24
In the DV mode, this function automatically transmits
the GPS receiver’s current position data, at a
selected interval, and should only be used in Simplex
transmission.
D
Setting the GPS automatic transmission
Push [MENU] q
to enter the Menu screen.
Push D-pad( w ) to select the root item (GPS), and
then push D-pad(Ent).
Push D-pad( e ) to select “GPS Auto TX,” and then
push D-pad(Ent).
Rotate [DIAL] to select a desired position data trans- r
mit interval.
• Selectable settings are OFF, 5*, 10, 30seconds
and 1, 3, 5, 10 and 30minutes.
* If four GPS sentences are selected in GPS SEN-
TENCE menu on page 5-16, “5sec” cannot be
selected.
• Selecting “OFF” cancels the GPS automatic trans-
mission.
• The GPS message is also transmitted, if pro-
grammed.
Push [MENU] t
to exit the Menu screen.
NOTE:
• Your own call sign must be entered to activate the GPS
automatic transmission.
• When the “GPS Select” menu on page 10-20 is set to
“OFF” or “Manual,” this function is disabled.
(MENU > GPS > GPS Set > GPS Select)
NOTE:
• Use GPS automatic transmission in only the simplex
mode.
• GPS automatic transmission through a repeater may in-
terfere with other communications.
When a GPS message is programmed, the transceiver
transmits it along with the position data. See page 5-17
for the GPS message programming.
■ GPS Auto transmission for only Simplex
To Next Page
Loading...
