Icom ID-31A

3
DR MODE <BASIC>
3-18
D “TO” (Destination) setting using the [Direct Input (RPT)]
The destination repeater call sign can be directly in-
put.
Example: Directly input the call sign “JP3YHH” (Hi-
rano430 repeater).
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “TO,” and then push D-
pad(Ent).
Push D-pad( e ) to select “Direct Input (RPT).”
Push D-pad(Ent) to enter the edit mode. r
Rotate [DIAL] to select a desired character. t
(For example: J)
• A to Z, 0 to 9, / and a space can be selected.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
Push D-pad( y ") to move the cursor to the second
digit.
Repeat steps u t and y to enter a name of up to 8
characters, including spaces.
(For example: First, J, then P, then 3, then Y, then
H, then H.)
After entering, push D-pad(Ent) twice. i
• “JP3YHH” is displayed on “TO.”
• After programming, you can correct the call sign in the
DIRECT INPUT (RPT) screen.
• The programmed call sign remains on the DIRECT IN-
PUT (RPT) screen, until inputting a new call sign.
NOTE: If the programmed call sign is duplicated to
the repeater list, the name is displayed. (Only when
the name has been programmed.)
“TO” (Destination) setting (Continued) ■
“JP3YHH” setting is completed.
If you input the call sign as shown below, it is cor-
rectly set.
The repeater
node is input.
“/” is input.
In this case, the call
sign is of a repeater
for a Gateway call.
D-pad
(�)
(Ent)
* Although the repeater node letter is ‘B’ for 430 MHz band,
‘A’ is used in Japan. See page 3-1 for details.
Previous view