Icom ID-31A

3
DR MODE <BASIC>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
3-21
For your reference ■
Besides the DR mode, you can use the VFO mode,
Memory mode or Call channel mode to make DV
calls.
D Making a Simplex call in the VFO mode
Push [V/MHz] q to select the VFO mode.
Push [FM/DV] w one or more times to select the
DV mode.
Set the desired simplex frequency. (p. 23 on the e
printed manual)
• Select the output power and audio volume, if desired.
(pp. 19, 26 on the printed manual)
• If duplex is ON, push
, then push D-pad() to select
“DUP,” and then push D-pad(Ent). Push D-pad() to se-
lect “OFF,” and then push D-pad(Ent) to turn it OFF.
Hold down r for 1 second to display the CALL
SIGN screen.
Push D-pad( t ) to select “UR,” and then push D-
pad(Ent).
Push D-pad( y ) to select the desired item, and then
push D-pad(Ent).
• CQCQCQ : Select to make a CQ call, or set CQ and
then just say the call sign of the station
you want to talk to.
• Your Call Sign : Select a station call sign in the Your Call
Sign memory to make a call.
• RX History : Select a station call sign in the RX His-
tory to make a call.
• TX History : Select a station call sign in the TX His-
tory to make a call.
Push D-pad( u ) to select “MY,” and then push D-
pad(Ent).
i Push D-pad() to select the desired MY Call sign
and then push D-pad(Ent).
Push [CLR] o to set, and exit the CALL SIGN
screen.
!0 While holding down [PTT], speak into the micro-
phone at your normal voice level.
• The TX/RX indicator lights red.
• The S/RF meter shows the transmit output power level.
!1 Release [PTT] to receive.
Information ✓
After setting, hold down [S.MW] for 1 second to
enter the Select Memory write mode, and then rotate
[DIAL] to select a desired memory channel.
Hold down [S.MW] for 1 second to save this pro-
grammed data into the channel.
D-pad
(�)
(Ent)
Select
Set
Set
Set
Shows the transmit
output power level
Settings are
completed
“CQCQCQ” select-
ed in “UR” scrolls.
Previous view