TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
I
• While operating D-STAR
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater
does not transmit a reply.
• The repeater setting is wrong.
• The transceiver is out of the repeater
range, or your transmission does not
reach the repeater.
• Set the correct repeater.
• Correct the repeater frequency, fre-
quency offset, or duplex setting.
• Try to access another repeater.
p. 3-7
p. 3-22
pp. 3-9,
3-12
After your call, the repeater
replies ‘UR?’ and its call
sign.
• The call was successfully sent, but no
station’s signal was immediately re-
ceived.
• Wait for a while, and try it again. p. 3-19
After your call, the repeater
replies ‘RX’ or ‘RPT?’ and
the call sign of its gateway
repeater.
• MY call sign has not been set.
• Your own call sign has not been reg-
istered to the D-STAR Server. Or it’s
wrong.
• Your calling station call sign has not
been registered to the D-STAR Server.
Or it’s wrong.
• Set the MY call sign.
• Register your own call sign to the D-
STAR Server. Or conrm the registra-
tion of your own call sign.
• Ask the server’s administrator about
your calling station’s call sign.
p. 2-5
—
—
After your call, the repeater
replies ‘RPT?’ and call sign
of the called repeater.
• The D-STAR cannot connect to the
called repeater, or it’s busy.
•
Wait for a while, and try it again. p. 3-19
After your call, the repeater
replies ‘RPT?’ and its call
sign.
• The call sign of the called repeater is
wrong.
• Correctly set the called repeater call
sign.
pp. 3-18,
3-22
Even holding down
, the
DR mode will not appear.
• The repeater list has been cleared. • Reprogram the repeater list using the
CS-31 cloning software.
• Reprogram the repeater list with the
transceiver.
pp. 11-11 to
11-15, 12-9
p. 4-19
Even holding down
, the
received call sign will not set
to the operating call sign.
• The call sign has not been correctly re-
ceived.
• Try it again, after the transceiver has
again received its call sign.
—
The repeater does not ac-
cept your gateway call.
•
Your call sign has not been registered to
the D-STAR system.
•
Ask your desired repeater’s adminis-
trator about call sign registration.
—
The simplex operation can-
not be made in the DR
mode.
•
A call sign is programmed in “CALL SIGN”
of the Repeater list.
•
Duplex mode (DUP+, DUP–) is set.
•
A repeater frequency is programmed.
•
Delete the Call sign
in “CALL SIGN”
setting of the Repeater list.
•
Select “OFF” in “DUP” setting of the
repeater list.
•
Program a simplex frequency.
p. 4-23
p. 4-23
p. 24 in
the Printed
manual
■ Troubleshooting
The following chart is designed to help you correct
problems which are not equipment malfunctions.
If you are unable to locate the cause of a problem
or solve it through the use of this chart, contact your
nearest Icom Dealer or Service Center.
To Next Page
Loading...
