Icom ID-31A

4
DR MODE <ADVANCED>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
4-21
■ Repeater list programming
This section describes how to manually program new
repeater information into the repeater list.
The required setting items differ, depending on the re-
peater use. Be sure to confirm the required items, as
shown to the right.
NOTE: To program the repeater information into the
repeater list, the repeater call sign MUST be en-
tered.
D New repeater programming
1. Repeater group selection
q Push [MENU]
.
w Push D-pad() to select the root item (“DV Memo-
ry”), and then push D-pad(Ent).
e Push D-pad() to select “Repeater List,” and then
push D-pad(Ent).
• The repeater groups are displayed.
r Push D-pad() to select the desired repeater group
to be programmed, and then push D-pad(Ent).
• The repeater list of the selected repeater group is dis-
played.
t Push .
y Push D-pad() to select “Add,” and then push D-
pad(Ent).
• REPEATER LIST EDIT screen is displayed.
Required items for the communication cases D
Repeater list
contents
Used as
an access
repeater
Used as a
destination
repeater
Used for a
simplex com-
munication
NAME – – –
SUB NAME – – –
CALL SIGN
✔ ✔
–*
1
GW CALL
SIGN
✔
(For Gateway call)
✔
–
GROUP – – –
USE(FROM)
✔
–
✔
FREQUENCY
✔
–
✔
DUP
✔
– –*
2
OFFSET FREQ
✔
– –
POSITION – – –
LATITUDE – – –
LONGITUDE – – –
UTC OFFSET – – –
*
1
This item MUST be blank.
*
2
This item MUST be set to “OFF.”
☞ Continued on the next page.
Select
*
* When you want to add a new repeater by editing a pro-
grammed repeater memory contents, select “Edit.” In this
case, after programming, be sure to select “<<Add Write>>.”
If you select “<<Overwrite>>,” the original repeater pro-
grammed contents are overwritten.
D-pad
(�)
(Ent)
Previous view