3
DR MODE <BASIC>
3-4
The calling station’s call sign can be used to quickly
and easily reply.
Example: Replying to a call from “JM1ZLK.”
After receiving a call, the LCD shows the calling sta-
tion’s call sign, as shown to the right.
While holding down q , rotate [DIAL] to select a
call sign to send a reply.
If you want to reply to the last calling station, hold
down for 1 second. (It is not necessary to ro-
tate [DIAL].)
• After selecting, release , and then the selected sta-
tion call sign is announced. (RX>CS Speech function*)
• When a call sign has not been received correctly, error
beeps sound, and no call sign is set.
• After selecting a call sign, the arrow icon blinks on “TO.”
While holding down [PTT], speak into the micro- w
phone at your normal voice level.
• The TX/RX indicator lights red.
• The S/RF meter shows the transmit output power level.
Release [PTT] to receive. e
• Push [CLR] to return to the previous screen. (The
arrow icon on “TO” disappears.)
* The RX>CS Speech function can be turned OFF in
“RX>CS SPEECH” on the MENU screen. (p. 10-49)
(MENU > SPEECH > RX>CS SPEECH)
■ One-touch reply after receiving a call
[DIAL]
[PTT]
Means you received a
call from “JM1ZLK.”
Blinks after se-
lecting a call sign.
Means you have re-
plied to “JM1ZLK.”
NOTE:
The call sign, used for the One-touch reply function,
is only for temporary operation, and if another call
sign is set, the previous call sign will be cleared.
To store the set call sign into the Your call sign mem-
ory, follow the procedures on pages 3-5 and 3-6.
To Next Page
Loading...
