7
MEMORY CHANNEL PROGRAMMING
7
7-3
■ Memory channel selection
The Memory mode is used for operation on memory
channels, which store programmed frequencies, call
signs and other data.
Push [M/CALL] q once or twice to select the
Memory mode.
• “MR” blinks when the Memory mode is selected.
• Push [M/CALL]
again to select the Call channels.
The Memory mode or Call channels are alternately se-
lected.
Rotate [DIAL] to select a desired memory channel. w
• Only programmed memory channels can be selected.
• See page 7-4 for memory programming details.
[DIAL]
■ Selecting a call channel
Call channels are used for quick recall of most often
used operating settings.
Push [M/CALL] q once or twice to select the Call
channels.
• Push [M/CALL] again to select the Memory mode.
Memory mode or Call channels are alternately select-
ed.
Rotate [DIAL] to select either the “C0” or “C1” Call w
channel.
[DIAL]
Appears
Rotate [DIAL] to change
the memory channel number
Rotate [DIAL] to select
To Next Page
Loading...
