4
DR MODE <ADVANCED>
4-2
■ Message operation
The transceiver has a total of 5 message memories
to store short messages to transmit during DV mode
operation. Messages of up to 20 characters can be
programmed in each memory.
D TX message programming
TX messages of up to 20 characters can be pro-
grammed in each of the 5 message memories.
Example: To program “JAPAN >TOM” into message
memory number 1.
Push [MENU] q .
Push D-pad( w ) to select the root item (“My Station”),
and then push D-pad(Ent).
Push D-pad( e ) to select “TX Message,” and then
push D-pad(Ent).
Push D-pad( r ) to select message memory number
“1.”
Push t .
Push D-pad( y ) to select “Edit.”
Push D-pad(Ent) to enter the TX message edit u
mode.
Rotate [DIAL] to select a desired character. i
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a character, push
to change the
character to a upper case or lower case letter.
• While selecting a digit, push
to open the input mode
selection window.
Push D-pad() to select the desired modes to Upper
case letters, Lower case letters, Numbers and Symbols.
To enter symbols, select “!”#,” and then push D-pad(Ent)
to display the symbol character selection window. And
rotate [DIAL] to select the desired symbol character, and
then push D-pad(Ent).
• A space can be selected, even for any input mode se-
lected.
• Push D-pad(") to enter a space to the right of the last
character.
To insert a space to the left of any selected character,
rotate [DIAL] to select a space to insert it.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
Push D-pad( o ") to move the cursor to the second
digit.
!0 Repeat steps i and o to enter up to 20 characters,
including spaces.
!1 After entering the message, push D-pad(Ent) one or
more times.
!2 Push [MENU] to exit the MENU screen.
“JAPAN” and a
space are entered.
Character type
selection screen
Symbol type
is selected
To input “>,”
[>] is selected
in the symbol
list screen.
“JAPAN >TOM”
is entered.
To Next Page
Loading...
