Icom ID-31A

7
MEMORY CHANNEL PROGRAMMING
7-6
D Memory or Call channelAnother mem-
ory or Call channel
Select the memory or call channel to be copied. q
Push [M/CALL] ➥ once or twice to select the
Memory mode or the Call channel mode, then
rotate [DIAL] to select a desired channel.
Hold down [S.MW] w
for 1 second to enter the
Select Memory write mode.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
• DO NOT hold down [S.MW]
for more than 2 sec-
onds. If you do, the memory contents will be copied to
the VFO.
Rotate [DIAL] to select the target memory or Call e
channel.
Hold down [S.MW] r for 1 second again to copy.
Copying memory and Call channel contents ■
(Continued)
[DIAL]
Select the memory
channel to be copied.
Hold down [S.MW]
for 1 second to enter
the Select Memory
write mode.
Rotate [DIAL] to select
the channel.
Hold down [S.MW]
for 1 second again to
copy.
Previous view