10
MENU SCREEN OPERATION
10-2
■ Menu items and Default settings
DUP/TONE...
Offset Freq
Repeater Tone
TSQL Freq
Tone Burst
DTCS Code
DTCS Polarity
Digital Code
0.000~5.000.00~59.995
In this item, set the repeater options, for example duplex offset or the channel tone types.
67.0~88.5~254.1
67.0~88.5~254.1
RANGE OR VALUE (Default is shown in bold)
OFF or ON
023~754
Both N, TN-RR, TR-RN or Both R
00~99
DESCRIPTIONS
NOTE: The default settings, shown below, are for the USA version.
The default settings may differ, depending on the version.
Sets the frequency offset for duplex
(repeater) operation.
Selects the tone frequency used to ac-
cess the repeaters.
Selects the DTCS polarity for the DTCS
squelch or the pocket beep function.
Selects the digital code for the Digital
Code squelch function.
Selects the tone frequency for the Tone
squelch or the pocket beep function.
Turns the Tone Burst function ON or
OFF. When this setting is ON and you
transmit a signal which superimposes
the CTCSS tone or subaudible tone,
the squelch tail noise of FM mode is
suppressed on the RX side.
Selects DTCS (both encoder/decoder)
code for DTCS squelch or the pocket
beep function.
To Next Page
Loading...
