Icom ID-31A

9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9-17
Checks the bank channels (priority channel) every
5 seconds, in sequence, while receiving on a VFO fre-
quency.
Push [V/MHz] q
to select the VFO mode.
Rotate [DIAL] to set the receive frequency. w
Push [M/CALL] e
to select the memory mode.
Push r
.
Push D-pad( t ) to select “Bank Select,” and then
push D-pad(Ent).
• The list of banks is displayed.
D-pad
(�)
(Ent)
Push D-pad( y ) to select the bank, and then push
D-pad(Ent).
Hold down [SCAN] u
for 1 second.
Push D-pad( i ) to select the scan type, and then
push D-pad(Ent) to start the bank scan (p. 8-8).
Push o
.
!0 Push D-pad() to select “PRIO Watch,” and then
push D-pad(Ent).
• ON : When a signal is received on the prior-
ity channel, the memory bank mode is
automatically selected.
• Bell : When a signal is received on the prior-
ity channel, the “
” icon is displayed
in the VFO mode.
!1 Push D-pad() to select “ON” or “Bell,” and then
push D-pad(Ent).
• The “PRIO” icon is displayed and the priority scan
starts.
• To cancel the scan, push [CLR]
.
■ VFO FREQUENCY AND BANK SCAN
Push .
Push
.
Bank scan starts.
Push [M/CALL]
.
Hold down [SCAN]
for 1 second.
[DIAL]
Appears
Appears
Blinks
Blinks
Checks the bank chan-
nel every 5 seconds.
Example: Sequentially checks the memory channels
in bank “Z” every 5 seconds, while receiving
432.380 MHz.
(Continued on page 9-18.)
Previous view