Icom ID-31A

1
REPEATER AND DUPLEX OPERATIONS
1-6
■ Auto repeater function
When the operating frequency falls within the repeater
output frequency range, the Auto Repeater function
can automatically sets the repeater settings (duplex
ON/OFF, duplex direction, tone encoder ON/OFF).
The Auto repeater function uses the preset repeater
tone frequency and frequency offset. See page 10-2
for details of the setting.
D Frequency range and offset direction
• U.S.A. version
FREQUENCY RANGE SHIFT DIRECTION
442.000–444.995 MHz “DUP+” is set
447.000–449.995 MHz “DUP–” is set
• Korean version
FREQUENCY RANGE SHIFT DIRECTION
439.000–440.000 MHz “DUP–” is set
Push D-pad( q ) to select the root item (“Function”),
and then push D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( w ) to select “Auto Repeater,” and then
push D-pad(Ent).
Rotate [DIAL] to select the Auto repeater setting. e
U.S.A. version:
• OFF : The Auto repeater function is OFF.
• ON (DUP) : Turns ON only the duplex operation.
(Default)
• ON (DUP, TONE) : Turns ON the duplex operation and
tone encoder
Korean version:
• OFF : The Auto repeater function is OFF.
• ON : Turns ON the duplex operation and
tone encoder. (Default)
Push [MENU] r to save and exit the [MENU]
screen.
NOTE:
When turned ON, the Auto repeater function uses
the preset repeater tone frequency and frequency
offset. See page 10-2 for details of the setting.
For the U.S.A. and Korean versions:
When turned ON, the Auto repeater function has pri-
ority over the manual duplex setting. If the transmit
frequency changes after setting, the Auto repeater
function may have changed the duplex setting.
[DIAL]
Previous view