8
SCAN OPERATION
8-4
■ VFO scan
There are 5 scan types: full scan, program scan, pro-
gram link scan, duplex scan and tone scan.
NOTE:
The frequencies that are set as skip channels
“PSKIP” are skipped during a scan.
When the “PROGRAM SKIP” item in the MENU screen
is set to OFF, the frequencies that are set as skip chan-
nels “PSKIP”, are not skipped during a scan.
D VFO mode scan
Push [V/MHz] q to select the VFO mode.
Push [FM/DV] w
to select the operating mode.
Hold down [SCAN] e
for 1 second.
Push D-pad( r
) to select the scan type.
• ALL : Full scan.
• P-LINK0–9 : Program link scan.
• P00–24 : Program scan.
• DUP : Duplex scan (p. 8-2).
(For the duplex mode)
• TONE : Tone scan.
(For tone squelch scanning)
Push D-pad(Ent) to start the scan. t
• If desired, rotate [DIAL] to switch the scanning direction
during a scan.
• If desired, push [FM/DV]
to change the operating
mode during a scan.
• If desired, hold down for 1 second [LOCK]
to turn
ON the Lock function during a scan.
To turn the function OFF, hold down [LOCK]
again
for 1 second.
• The scan resumes even while the MENU screen is dis-
played.
To cancel the scan, hold down [SCAN] y for
1 second.
• Pushing [CLR] also cancels the scan.
CONVENIENCE!
Holding down [SCAN] and rotate [DIAL] also
selects the scan type. The scan immediately starts
when [SCAN] is released.
Hold down [SCAN]
for 1 second.
Push D-pad(Ent).
Blinks
Blinks
Blinks
Blinks
e.g. The full scan in the FM mode.
When a signal is received.
The S-meter shows the re-
ceived signal strength.
[DIAL]
To Next Page
Loading...
