Icom ID-31A - Gps Logger Only; Gps Tx Mode

10
MENU SCREEN OPERATION
10-30
GPS items (Continued) ■
<<GPS Logger Only>>
GPS > GPS Logger > <<GPS Logger Only>>
The transceiver switches into an exclusive GPS logger mode where only
the logger is functioning.
• Select “Internal GPS” or “External GPS” in GPS Select screen and in-
sert a microSD card.
• During the exclusive GPS logger mode, the transceiver's transmission
and reception are disabled.
To cancel the exclusive GPS logger mode, reboot the transceiver.
Push D-pad(Ent). q
D-pad
(�)
(Ent)
Push D-pad( w )) to select “YES,” and then push D-pad(Ent).
• When the GPS logger function is set to “ON,” the GPS logger mode is started
immediately after pushing D-pad(Ent).
GPS TX Mode (Default: OFF)
GPS > GPS TX Mode(GPS TX MODE)
Select a GPS transmission mode to send position data received from a
GPS receiver while in the DV mode.
• OFF : Position data is not transmitted.
• GPS (DV-G) : Transmits position data in NMEA format. (the TX GPS
mode is “GPS”)
• GPS-A (DV-A) : Transmits position data in the format corresponding to D-
PRS. (the TX GPS mode is “GPS-A”)
In the GPS-A mode, the normal GPS-A codes are trans-
mitted to the PC connected to the ID-31A/E.
GPS-A code is based on APRS
®
code. (APRS
®
: Auto-
matic Packet Reporting System)
When “GPS” or “GPS-A” is selected, the slow-speed data communica-
tion is disabled. (p. 4-12)
Previous view