Icom ID-31A

4
DR MODE <ADVANCED>
4-20
■ Repeater list
You can store repeater information for quick and simple
communication in up to 700 repeater memory chan-
nels (Repeater list) in up to 20 Groups.
Programming the repeater list is required for DR mode
operation.
D Repeater list contents
The following contents are included in the repeater
list:
• NAME (Repeater name) (p. 4-22)
• SUB NAME (Repeater sub name) (p. 4-22)
• CALL SIGN (Repeater call sign and port letter)
(p. 4-23)
• GW CALL SIGN (Gateway repeater’s call sign and
port “G”) (p. 4-24)
• GROUP (Repeater group) (p. 4-24)
• USE(FROM) (Access repeater use) (p. 4-25)
• FREQUENCY (Access repeater’s input frequency)*
(p. 4-25)
• DUP (Duplex direction)* (p. 4-26)
• OFFSET FREQ (Frequency offset)* (p. 4-26)
• POSITION (Position data accuracy level) (p. 4-26)
• LATITUDE (Latitude position of the repeater)
(p. 4-27)
• LONGITUDE (Longitude position of the repeater)
(p. 4-27)
• UTC OFFSET (UTC Offset) (p. 4-27)
* Appears only when USE(FROM) is selected as YES.
Example: “Hamacho430” repeater information
NOTE: For easy operation, the repeater list is load-
ed into your transceiver. However, if the CPU clears
all programmed contents (All Reset), the repeater
list is also cleared. We recommend that memory
data be backed up externally or be saved to a PC
using the supplied CS-31 c l o n i n g s o f t w a r e .
About the repeater list:
The repeater list can be downloaded from our web-
site.
http://www.icom.co.jp/world/index.html
Previous view