Icom ID-31A

4
DR MODE <ADVANCED>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
4-27
Latitude programming12.
This item appears only when “Approximate” or “Ex-
act” is selected in [11. Position data accuracy level
setting].
$7 Push D-pad() to select “LATITUDE,” and then push
D-pad(Ent) to enter the latitude data edit mode.
• A cursor appears and blinks.
$8 Rotate [DIAL] to input the latitude data.
$9 Push to move the cursor backward, or push to
move the cursor forward.
%0 Repeat steps $8 and $9 to enter the latitude data.
%1 After entering, push D-pad(Ent).
Longitude programming13.
This item appears only when “Approximate” or “Ex-
act” is selected in [11. Position data accuracy level
setting].
%2 Push D-pad() to select “LONGITUDE,” and then
push D-pad(Ent) to enter the longitude data edit
mode.
• A cursor appears and blinks.
%3 Rotate [DIAL] to input the longitude data.
%4 Push to move the cursor backward, or push to
move the cursor forward.
%5 Repeat steps %3 and %4 to enter the longitude data.
%6 After entering, push D-pad(Ent).
UTC Offset programming14.
UTC (Universal Time Coordinated) offset is the time
difference between UTC and repeater local time.
This item enables you to check the destination re-
peater’s time when you make a gateway call.
%7 Push D-pad() to select “UTC OFFSET,” and then
push D-pad(Ent) to enter the UTC offset edit mode.
%8 Rotate [DIAL] to input the time difference between
UTC and the local time.
%9 Push
to move the cursor backward, or push to
move the cursor forward.
^0 Repeat steps %8 and %9 to enter the UTC offset.
^1 After entering, push D-pad(Ent).
Previous view