3
DR MODE <BASIC>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
3-7
1: Using [DIAL] (p. 3-2)
Select the repeater preloaded in your transceiver by
rotating [DIAL].*
When you know your access repeater
2: From the repeater list (p. 3-8)
Select the repeater preloaded in your transceiver’s
repeater list.*
When you don't know which repeater you can access.
3: Search for the nearest repeater (p. 3-9)
The transceiver searches the nearest repeater by
using your own and repeater’s position data.
When the “FROM” data is stored in the TX History.
4: Setting from the TX History (p. 3-11)
When you transmit a call in the DR mode, “FROM”
(the access repeater) data is stored in the TX His-
tory.
You can select the access repeater from the record.
When you don't know which repeater you can access.
5: Search for a repeater using the DR mode scan
(p. 3-12)
Searches for DV signals from a repeater or a sim-
plex frequency.
Your access repeater must be set to “FROM” when you
transmit a call in the DR mode.
You have five ways to set the access repeater.
Click the title shown below to jump to the specified
page.
When using [DIAL]
[FROM SELECT] screen
While DR mode scanning
Blinks
■ “FROM” (Access repeater) setting
How to switch the repeater group:
While in the DR mode, push ➥ to display the
quick menu. Then push D-pad() to select [Group
Select].
• You can switch the repeater group using D-pad()
* Before selecting, be sure to load the desired repeater list in
your transceiver. (p. 12-9)
To Next Page
Loading...
