Icom ID-31A

5
GPS/GPS-A OPERATION
5-14
GPS memory operation ■ (Continued)
D GPS alarm setting
A GPS alarm can sound when a target position comes
into the alarm area.
This function can be set to the caller station, all GPS
Memory channels, a specified Memory bank or a
specified Memory channel.
Example: Alarm Area 1
Setting alarm to all GPS Memories.
Push [MENU] q .
Push D-pad( w ) to select the root item (GPS), and
then push D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( e ) to select “GPS Memory,” and then
push D-pad(Ent).
Push D-pad( r ) to select “ALL.”
• If you wish to set the alarm to a GPS Memory
bank, select one between A to Z.
Push t .
Push D-pad( y ) to select “Alarm ON,” and then push
D-pad(Ent).
• When the alarm is set, is displayed next to the
item.
u Push [MENU] to exit the Menu screen.
• When either one of the stations in a specified group
enters its set range, the beep sounds three times.
• When the GPS alarm beeps, “GPS ALARM” pops
up on the screen and then the S icon blinks.
• To cancel the GPS alarm, repeat step t and se-
lect “Alarm OFF.”
The pop up is
displayed and
beeps 3 times.
S blinks
When alarm
is set,
is
displayed.
0.25’ 0.25’
0.25’0.25’
N
Your
position
Your
position
Extended range
(approx. 1 km; 1094 Y)
Limited range
(approx. 500m; 547Y)
Beeps one times
Beeps three times
Beeps three times
When all channels or bank is selected:
Alarm area 1 (Setting plural stations)
When a specified memory is selected:
Alarm area 2 (Setting specic stations)
Point A
Point B
Point C
NOTE: When “ALL” or a memory bank is selected, the
alarm functions depend on the “Alarm Area1” setting in
the Menu screen. (p. 10-24)
(MENU > GPS > GPS Set > Alarm Area 1)
• GPS Alarm beeping screen
Previous view