Icom ID-31A

7
MEMORY CHANNEL PROGRAMMING
7-4
■ Memory channel programming
[Example]: Programming 430.520 MHz/FM mode into
memory channel 11 (a blank channel).
Push [V/MHz] q to select the VFO mode.
Set a desired frequency and operating mode: w
Rotate [DIAL] to set a desired frequency. ➥
Push [FM/DV] one or more times to select a de- ➥
sired operating mode.
Set the duplex direction, frequency offset, tone ➥
squelch, and so on, if needed.
Hold down [S.MW] e
for 1 second to enter the
Select Memory write mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks.
Rotate [DIAL] to select a desired channel. r
Hold down [S.MW] t
for 1 second to save.
• 3 beeps sound.
• Before returning to the VFO mode, the programmed
memory contents are displayed.
• The Memory channel number automatically increases
when continuing to hold down [S.MW]
for 1 second
after saving.
NOTE:
• Push [CLR]
to cancel the program and exit the Se-
lect Memory write mode before memory programming is
saved.
• Call channels (C0, C1), VFO and scan edge channels
(00A/00B to 24A/24B), as well as regular memory chan-
nels, can be programmed in this same way.
[DIAL]
Set 430.520MHz in
the VFO mode.
Hold down [S.MW]
to
enter the Select Memory
write mode
Rotate [DIAL] to select
channel 011
Hold down [S.MW]
for 1 second to program.
Returns to the VFO mode.
Previous view