4
DR MODE <ADVANCED>
4-22
Repeater list programming (Continued) ■
2. Repeater name programming
u Push D-pad(
) to select “NAME,” and then push D-
pad(Ent) to enter the repeater name edit mode.
i Rotate [DIAL] to select a desired character.
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a character, push
to change the
character to a upper case or lower case letter.
• While selecting a digit, push
to open the input mode
selection window.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
• See page 4-2 for programming details.
o Push D-pad(") to move the cursor to the second
digit.
!0 Repeat steps i and o to enter a name of up to 16
characters, including spaces.
!1 After entering the name, push D-pad(Ent).
3. Repeater sub name programming
!2 Push D-pad(
) to select “SUB NAME,” and then
push D-pad(Ent) to enter the repeater sub name
edit mode.
!3 Rotate [DIAL] to select a desired character.
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a character, push
to change the
character to a upper case or lower case letter.
• While selecting a digit, push
to open the input mode
selection window.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
• See page 4-2 for programming details.
!4 Push D-pad(") to move the cursor to the second
digit.
!5 Repeat steps !3 and !4 to enter a sub name of up to
8 characters, including spaces.
!6 After entering the name, push D-pad(Ent).
Character type
selection screen
Character type
selection screen
Example:
“East Tokyo” is
entered.
Example:
“Japan” is en-
tered.
To Next Page
Loading...
