7
MEMORY CHANNEL PROGRAMMING
7-8
D Directly programming in to a memory
bank
Example: Programming 432.000 MHz,FM mode into
memory bank channel J-01.
Push [V/MHz] q
to select the VFO mode.
Set a desired frequency and operating mode: w
Rotate [DIAL] to set a desired frequency. (Exam- ➥
ple: 432.000 MHz)
Push [FM/DV] one or more times to select a de- ➥
sired operating mode. (Example: FM mode)
Set duplex direction, frequency offset, tone ➥
squelch and so on, if desired.
Hold down [S.MW] e for 1 second to enter the
Select Memory write mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks.
Push r to open the Quick Menu screen.
Push D-pad( t ) to select “Bank Select,” and then
push D-pad(Ent).
Rotate [DIAL] to select a desired bank group, “A” to y
“Z,” and then push D-pad(Ent).
• If you want to change the bank group after pushing
D-pad(Ent), return to step r.
Rotate [DIAL] to select a desired or blank bank u
channel between “00” and “99.”
• The bank channel number blinks.
• If the selected bank channel has already been assigned,
the memory contents are displayed.
Hold down [S.MW] i for 1 second to program.
• 3 beeps sound.
• If an already assigned bank channel is selected in step
u, the memory contents will be overwritten into the
memory channel and bank channel.
• The Bank channel number automatically increases when
continuing to hold down [S.MW]
for 1 second after
programming.
• Returns to the VFO mode.
NOTE:
If the Memory bank display is already selected and
you want to program the contents into the memory
channel, perform following operations.
Select “ALL CH Select” in step ➥ t.
Rotate [DIAL] to select a desired memory channel. ➥
➥
Hold down [S.MW] for 1 second to program.
Memory bank setting ■ (Continued)
Push [CLR] to cancel the program and exit
the Select Memory write mode before memory pro-
gramming is finished.
Hold down
[S.MW]
for
1 second to enter
the Select Memory
write mode.
Push D-pad() to
select “Bank Select.”
Select the bank
group, “J.”
The bank channel
number blinks.
Rotate [DIAL] to se-
lect the bank chan-
nel “01.”
Hold down
for 1
second to program.
Returns to the VFO
mode.
You can also program the memory contents directly
into a memory bank channel. This way is a short cut to
programming the memory channel, and then assigning
it to a bank. In that case, the transceiver automatically
selects the lowest blank memory channel, to program.
To Next Page
Loading...
