4
DR MODE <ADVANCED>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
4-33
■ Repeater group name programming
Push [MENU] q .
Push D-pad( w ) to select the root item (“DV Memo-
ry”), and then push D-pad(Ent).
Push D-pad( e ) to select “Repeater List,” and then
push D-pad(Ent).
Push D-pad( r ) to select the repeater group you
want to program the name.
Push t .
Push D-pad( y ) to select “Edit Name,” and then push
D-pad(Ent) to enter the group name edit mode.
Rotate [DIAL] to select a desired character. u
• The selected character blinks.
• Push D-pad() to move the cursor right or left.
• While selecting a character, push
to change the
character to a upper case or lower case letter.
• While selecting a digit, push
to open the input mode
selection window.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
• See page 4-2 for programming details.
Push D-pad( i ") to move the cursor to the second
digit.
Repeat steps o u and i to enter a name of up to 16
characters, including spaces.
!0 After entering, push D-pad(Ent).
Character type
selection screen
Group name
edit mode
Example:
“ASIA” is programmed.
To Next Page
Loading...
