Icom ID-31A

11
OTHER FUNCTIONS
11-2
■ Using the DTMF memory
The transceiver can stores up to 16 channels of DTMF
memory with 24-digit DTMF code.
D DTMF code programming
Push [MENU] q to select the MENU list screen.
To display the DTMF MEMORY screen, push w
D-pad() to select the root item (DTMF/T-CALL),
and then push D-pad(Ent) to go to the next level.
• DTMF memory channel list (d0 to d#) is displayed.
Push D-pad( e ) to select the desired DTMF memory
channel, then push .
Push D-pad( r ) to select “Edit, ”then push D-pad(Ent)
to enter DTMF memory edit mode.
Rotate [DIAL] to select the desired code, the push t
D-pad(Ent) to set the code.
Repeat the above step to enter the desired DTMF
codes.
• Push to move the cursor backward, or push to
move the cursor forward.
* When the cursor is on the 24th digit, the cursor only can
be move to backward.
• Push [CLR]
to delete the selected code.
• When the cursor does not select a character, the previ-
ous character is deleted.
If [CLR]
is held down, all the characters are de-
leted.
When all digits are set, push D-pad(Ent). y
• The entered DTMF codes are stored into the DTMF
memory channel, and automatically return to DTMF
memory screen.
u Push [MENU] to return to the operating screen.
DTMF memory edit mode
In case of a DTMF code
has been stored
Example: Stores the DTMF code, “012345” into the
DTMF memory channel “d0.”
Rotate [DIAL] to select the
desired code
Push D-pad(Ent)
Push [MENU]
Blinks (during character select)
Stored DTMF code
Cursor
D-pad
(�)
(Ent)
[DIAL]
Push
Previous view