Icom ID-31A

9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9-33
Checks the memory channel (priority channel) every 5
seconds, during a DR mode scan.
q Push [M/CALL]
to select the memory mode.
Rotate [DIAL] to select the channel you want to w
watch.
Hold down [DR] e
for 1 second to select the DR
mode.
Hold down [SCAN] r
for 1 second.
• The DR scan starts.
Push t
.
Push D-pad( y ) to select “PRIO Watch,” and then
push D-pad(Ent).
• ON : When a signal is received on the priority
channel, the memory mode is automati-
cally selected.
• Bell : When a signal is received on the priority
channel, a beep sounds and the “PRIO”
icon blinks on the DR mode screen.
D-pad
(�)
(Ent)
Push D-pad( u ) to select “ON” or “Bell,” and then
push D-pad(Ent).
• The “PRIO” icon is displayed and the priority scan
starts.
• Regardless of the scan setting, when a signal is re-
ceived during the DR scan, the transceiver continues to
check the memory channel every 5 seconds.
• Push [CLR]
to cancel the priority scan and DR
mode scan.
■ DR MODE SCAN AND MEMORY CHANNEL
Push .
Hold down [SCAN]
for 1 second.
[DIAL]
Appears Appears
Blinks
Blinks
Checks the memory
channel every 5 sec-
onds.
The DR mode scan starts.
During the DR mode scan.
Example: Checks memory channel “490” every 5 sec-
onds, during the DR mode scan.
(Continued on page 9-34.)
Hold down [DR] for 1 sec-
ond.
Previous view