Icom ID-31A

8
SCAN OPERATION
8-8
D Memory bank scan
A memory bank scan searches through the memory
channels in the selected bank.
• Two or more memory channels, which are not set
as skip channels, must be programmed into start a
memory bank scan.
• When the “BANK” item in the MENU screen is set to
“OFF,” a bank scan is not started.
Push [M/CALL] q
to select the memory mode.
Hold down [FM/DV] w
for 1 second.
Push D-pad ( e ) to select the scan type.
• ALL : Full bank scan
• BANK-LINK : Bank link scan
• BANK-A to Z : Bank scan
( Only banks which contain a memory
channel are displayed.)
• DUP : Duplex scan (p. 8-2)
(For the duplex mode)
• TONE : Tone scan
(For tone scanning)
Push D-pad(Ent) to start the scan. r
To cancel the scan, hold down [SCAN] t
for
1 second.
• Pushing [CLR] also cancels the scan.
NOTICE
• The bank contains only channels which are set as
“SKIP” or “PSKIP” is skipped.
• When the all selected banks contain only channels
which are set as “SKIP” or “PSKIP,” the scan is not
started.
Hold down [SCAN] for
1 second.
Push D-pad(Ent).
When a signal is received.
Blinks
Blinks
Blinks
Bank channel
Blinks
The S-meter shows the re-
ceived signal strength.
CONVENIENCE!
Holding down [SCAN]
and rotate [DIAL] also se-
lects the scan type. The scan immediately starts
when [SCAN] is released.
D-pad
(�)
(Ent)
Previous view