3
DR MODE <BASIC>
3-2
■ Making a Local area call
To call a station through your local area (access) repeater.
D Making a CQ call through your local area
(access) repeater (Local Area CQ)
This section describes how to make a call through your
local area (access) repeater.
Example: Making a local CQ call by accessing the
“Hamacho430” repeater.
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “FROM” (Access repeater).
Rotate [DIAL] to select “Hamacho430.” e
Push D-pad( r ) to select “TO” (Destination), and then
push D-pad(Ent).
Push D-pad( t ) to select “Local CQ,” and then push
D-pad(Ent).
• “CQCQCQ” is displayed on “TO.”
While holding down [PTT], speak into the micro- y
phone at your normal voice level.
• The TX/RX indicator lights red.
• The S/RF meter shows the transmit output power level.
Release [PTT] to receive. u
JM1ZLK listening on
JP1YIU port A*...
‘JM1ZLK listening on
JP1YIU port A*...’
[DIAL]
[PTT]
Means this repeat-
er is programmed
as the 3rd of 635
repeaters in the
repeater list.
Shows the transmit
output power level
To maximize the readability of your signal, hold the
microphone 5 to 10 cm (2 to 4 inches) from your
mouth, then speak at a normal voice level.
Hamacho430
repeater
Hamacho area (Tokyo)
Settings are
complete
Caller:
JM1ZLK
Called
* Set the repeater node
to ‘B’ for 430 MHz band,
when you use in other
than Japan. See page
3-1 for details.
“CQCQCQ” select-
ed in “TO” scrolls.
To Next Page
Loading...
