Icom ID-31A

10
MENU SCREEN OPERATION
10-62
■ Sounds items
Beep Level (Default: 3)
Sounds > Beep Level(BEEP LEVEL)
Select a beep audio output level between 0 (OFF), 1 (minimum) and 9
(maximum).
Beep/Vol Level Link (Default: OFF)
Sounds > Beep/Vol Level Link(BEEP/VOL LEVEL LINK)
Select whether or not the beep output level can be adjusted by the [VOL]
control.
• OFF : The output level is xed to the level set in Beep Level.
• ON : The output level can be adjusted by rotating [VOL].
Key-Touch Beep (Default: ON)
Sounds > Key-Touch Beep(KEY-TOUCH BEEP)
Turn the confirmation beep tones ON or OFF.
• OFF : Turns the function OFF for silent operation.
• ON : A beep sounds when a key is pushed.
NOTE:The beep tone sounds regardless of this setting when;
- the power is turned ON
- a matched tone signal is received if the pocket beep is activated.
- the transceiver is automatically turned OFF. (The beep sounds before
powering OFF.)
- TOT (Time-Out Timer) function is activated. (Approximately 10 seconds
before the Time-Out Timer cuts off transmission.)
- the cloning read or write operation starts or finishes.
- a received signal stops the scan. (Scan Stop Beep)
- the communicating station finishes transmitting or the receive signal
disappears while in the digital mode operation. (Standby Beep)
Scan Stop Beep (Default: OFF)
Sounds > Scan Stop Beep(SCAN STOP BEEP)
Turn the scan stop beep ON or OFF.
• OFF : No beep sounds.
• ON : A beep sounds when a received signal stops the scan.
Previous view