8
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
8-7
■ Memory scan
There two types of scan in the memory mode: Memory
scan and memory bank scan.
• Channels set as “PSKIP” or “SKIP” is skipped during
a scan.
•
Two or more memory channels, which are not set as skip
channels, must be programmed into start a memory scan.
D Setting the skip memory channel
The memory channels set as “PSKIP” or “SKIP” skip
channels are not scanned.
Push [M/CALL] q
to select the memory mode.
Hold down [FM/DV] w
for 1 second.
Push D-pad( e
) to select the scan type.
• ALL : Full scan
• MODE : Mode memory scan
• DUP : Duplex scan (p. 8-2)
(For the duplex mode)
• TONE : Tone scan (For tone scanning)
Push D-pad(Ent) to start the scan. r
• If desired, rotate [DIAL] to switch the scanning direction
during a scan.
• If desired, hold down for 1 second [LOCK]
to turn
ON the Lock function during a scan.
To turn the function OFF, hold down [LOCK]
again
for 1 second.
• The scan resumes even while the MENU screen is dis-
played.
To cancel the scan, hold down [SCAN] t for
1 second.
• Pushing [CLR] also cancels the scan.
CONVENIENCE!
Holding down [SCAN]
and then rotating [DIAL]
also selects the scan type. The scan immediately
starts when [SCAN] is released.
Hold down [SCAN]
for 1 second.
Push D-pad(Ent).
When a signal is received.
Blinks
Memory channel number
Blinks
Blinks
Blinks
The S-meter shows the re-
ceived signal strength.
[DIAL]
To Next Page
Loading...
