Icom ID-31A

9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9-25
Checks the VFO frequency (priority channel) every
5 seconds, during a DR mode scan.
Push [V/MHz] q
to select the VFO mode.
Rotate [DIAL] to set the receive frequency. w
Hold down [DR] e
for 1 second to select the DR
mode.
Hold down [SCAN] r
for 1 second.
• The DR mode scan starts.
Push t
.
Push D-pad( y ) to select “PRIO Watch,” and then
push D-pad(Ent).
• ON : When a signal is received on the priority
channel, the VFO mode is automatically
selected.
• Bell : When a signal is received on the priority
channel, a beep sounds and the “PRIO”
icon blinks on the DR mode screen.
D-pad
(�)
(Ent)
Push D-pad( u ) to select “ON” or “Bell,” and then
push D-pad(Ent).
• The “PRIO” icon is displayed and the priority scan
starts.
• Regardless of the scan setting, when a signal is re-
ceived during the DR mode scan, the transceiver con-
tinues to check the VFO frequency every 5 seconds.
• Push [CLR]
to cancel the priority scan and DR
mode scan.
■ DR MODE SCAN AND VFO FREQUENCY
Push .
Appears
Blinks
Appears
Hold down [SCAN]
for 1 second.
Hold down [DR]
for 1 sec-
ond.
The DR mode scan starts.
[DIAL]
Checks the VFO fre-
quency every 5 sec-
onds.
Example: Checks “432.380 MHz” every 5 seconds,
during the DR mode scan
(Continued on page 9-26.)
Blinks
Previous view