Icom ID-31A

7
MEMORY CHANNEL PROGRAMMING
7
7-5
■ Copying memory and Call channel contents
This function copies a memory channel’s contents to
the VFO, another memory or Call channels. This is
useful when searching for signals around a memory
channel frequency, and for recalling the frequency off-
set, subaudible tone frequency and so on.
D Memory or Call channelVFO
Select the memory or call channel to be copied. q
Push [M/CALL] ➥ once or twice to select the
Memory mode (or the Call channel mode,) then
rotate [DIAL] to select a desired channel.
Hold down [S.MW] w
for 1 second to enter the
Select Memory write mode and copy the memory
contents.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
Rotate [DIAL] to select “VFO.” e
Hold down [S.MW] r
for 1 second to write the se-
lected channel contents to the VFO.
• The transceiver automatically returns to the VFO.
[DIAL]
Holding down [S.MW] for 2 seconds in step w
will also copy the memory contents to the VFO. In that
case, steps e and r are not necessary.
Select the memory or call
channel to be copied.
Hold down [S.MW]
for 1 second to enter the
VFO mode.
VFO mode screen
appears.
Previous view