Icom ID-31A

9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
9-15
Checks the memory channels (priority channel) every
5 seconds, in sequence, while receiving on a VFO fre-
quency.
Push [V/MHz] q
to select the VFO mode.
Rotate [DIAL] to set the receive frequency. w
Push [M/CALL] e
to select the memory mode.
Hold down [SCAN] r
for 1 second.
Push D-pad( t ) to select the scan type, and then
push D-pad(Ent) to start the memory scan (p. 8-7).
D-pad
(�)
(Ent)
Push y .
Push D-pad( u ) to select “PRIO Watch,” and then
push D-pad(Ent).
• ON : When a signal is received on the prior-
ity channel, the memory mode is auto-
matically selected.
• Bell : When a signal is received on the prior-
ity channel, the “
” icon is displayed
in the VFO mode.
Push D-pad( i ) to select “ON” or “Bell,” and then
push D-pad(Ent).
• The “PRIO” icon is displayed and the priority scan
starts.
• To cancel the scan, push [CLR]
.
■ VFO FREQUENCY AND MEMORY SCAN
Appears Appears
Blinks
Example: Sequentially checks the memory channels
every 5 seconds, while receiving on 432.380
MHz.
Blinks
Checks the memory
channel every 5 sec-
onds.
Push
.
Hold down [SCAN]
for 1 second.
[DIAL]
(Continued on page 9-16.)
Previous view