3
DR MODE <BASIC>
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
3-17
D “TO” (Destination) setting using the [Direct Input (UR)]
The destination station call sign can be directly input.
Example: Directly input the call sign “JM1ZLK.”
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “TO,” and then push D-
pad(Ent).
Push D-pad( e ) to select “Direct Input (UR).”
Push D-pad(Ent) to enter the edit mode. r
Rotate [DIAL] to select a desired character. t
(For example: J)
• A to Z, 0 to 9, / and a space can be selected.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters
after the cursor.
Push D-pad( y ") to move the cursor to the second
digit.
Repeat steps u t and y to enter a call sign of up to
8 characters, including spaces.
(For example: First, J, then M, then 1, then Z, then
L, then K.)
After entering, push D-pad(Ent) twice. i
• “JM1ZLK” is displayed in “TO.”
• After programming, you can correct the call sign in the
DIRECT INPUT (UR) screen.
• The programmed call sign remains on the DIRECT IN-
PUT (UR) screen, until inputting a new call sign.
NOTE: If the programmed call sign is duplicated in
“Your Call Sign” memory, the name is displayed.
(Only when the name has been programmed.)
“JM1ZLK” setting is completed.
To Next Page
Loading...
